ATS Transfer Switchmanual transfer switch for portable generator
(RDS3-E)
NEW FEATURES ARRIVAL:
1, RS485 communication function available with RDS3 type.
2, Generator exerciser timer (Engine exerciser) is available, user
can set the generator start daily, weekly or monthly. You can also
choose the generator exerciser load mode, to test the generator on
load or off-load. It is applied to the place where generator is not
frequently used.
3, Under manual mode, by press "+" button to start or stop the
generator manually.
4, High and low Frequency (Hz) protection.
5, ATS setting menu with password protected.
6, Center Time Delay
Radin Electric provides ATS design, engineering, and full after
sales support for a wide range of automatic transfer switch
applications. We offer onsite electrical audits to assist in
determining the correct product and installation to meet your exact
needs and requirements.
Product Name | RDS3 Series Dual Power Automatic Transfer Switch |
Type | PC Type |
Material Of Cover | PC |
Standard | GB/T14048.11, IEC60947-6-1 |
Poles | 3P/4P |
Current | 16A-630A |
Controller Type | B: Three phase power failure monitoring + generator control + fire-
linkage + LED running status indication
C: Intelligent LCD control panel with parameters settings + B type
D: RS485 + C type
E: Over/under voltage auto transfer, Over/Under frequency
protection + Engine exercise + D type. |
Use Category | AC-33B |
About ATS
RDS3 Series PC class dual power Auto transfer switch, mainly used
in two way power supply system with rated voltage below 400V, AC
50/60Hz, rated current up to 630A, when one power supply abnormal,
then it transfer between two power supply system, to ensure the
power supply reliablity and safety.
The ATS have " Main Power", "Backup Power" and "Two way OFF"
positions, with higher breaking and making capacity, it not only
can meet normal load transfer, but also can meet high inductive
impedance or big motor load transfer, meanwhile due to have high
short time withstand current capacity, no need special SPCD,
doesn't affect the selective of inside circuit, meanwhile it also
can meet the application at big capacity power supply side.
Product confirm to GB/T14048.11<<Low voltage switch equipment
and control equipment Part 6-1: multi-funtional transfer switch
equipment>> Standard
RDS3 Advantages:
a. Control power voltage:AC 230V
b. Auto Transfer: Auto transfer auto recovery,auto transfer no auto
recovery,power grid-generator
c. Manual transfer: Manual main power,manual backup power,manual
OFF
d. Isolation lock: Off position have isolation function,also can
padlock locked
e. Generator control: Generator start and stop
f. Fire linkage: With passove fire linkage signal to switch OFF the
device,with one set passive NO feedback contact.
g. Display mode: Mechanical indication;device ON/OFF status
operating mode
LED: device ON/OFF status,power status
LCD: device ON/OFF status,power status,data setting
h. Setting mode: Key-press operation,Chinese/English display
interface,can set the working mode,low-voltage value, over-voltage
value, delay time, auto transfer mode etc.
i. Power monitoring: ABC three phase over-voltage (240-290v
adjustable)
ABC three phase low-voltage (150-200v adjustable)
ABC three phase missing monitor
j. Delay time: Transfer delay (0-300s adjustable)
Recovery delay (0-300s adjustable)
Generator start,stop delay (0-300s adjustable)
k. Mounting mode: Integated mounting
Working conditions
a. Ambient temperature: -20ºC---+40ºC; 24 hours average not more
than +35ºC
b. Atmospheric conditions: humidity not more than 50% at max.
+40ºC,higher humidity is allowed at lower temperature,at most wet
month,the average max humidity is 90% at the average min
temperature +25ºC,and have considered the condensation on the
product surface due to temperature variation;
c. Altitude: Not more than 2000m
d. Pollution Class: The installation site environment pollution
class 3
Dlivery Terms
Shipment & Express & Air express
Packing
FAQ:
1. What's the warranty term?
24 Monthes.
2. How long does it take to deliver my goods?
Normally, samples can be delivered in 2 days. Customer designed
sampleswill be delivered in 3-7 days.
3. Do you offer sample?
Yes, we offer sample order for customer to test the goods.
4. What kinds of payment terms do you accept?
We offer kinds of payment ways foe customer to chose from.
T/T,L/C,Aliexpress,Western union etc.
5. What if there's quality peoblem?
We offer replacement for the goods as soon as there is a quality
problem with the goods, and the fright is on our account to cut
down the customer's loss to the lowest.
We are sure any of your questions will get our prompt reply, just
leave the message!
